INSTALLING WACOM TABLET AN OS/2 PENPM MACHINE

DIP SWITCHES CAN BE CHANGED TO UP THE DATA RATE.

When the pinstall program requests a drive and directory, for the 
PenPM device driver, enter this drive and directory. Depending on 
the version of pinstall.exe the driver may or may not install 
correctly. If it does not install properly, follow the instructions below

This driver was tested with  a PL100V, SD-510, ArtPad, UD-0608, and SD-42x
tablets.
It 'should' work with other wacom tablets. 
Let me know if it does not and I will fix it. 

*
*  dip switches on the 510 or 42x to binary  and 19200 baud   
* as derscribed below
*
*       baud rate:   +19200    -9600
*                         \    /
*        binary            \  /
*       /                   /
*  + + - - - - - -     + + ? - - - - +     + + + + + + - -    


You can also install the driver for the wacom SD-510C from the 
IBM disks and modify your config.sys file as described below.

Copy the file wacomos2.sys from this disk to the hard drive. 

Modify the OS2 config.sys file so that the line that says 
"DEVICE=C:\.....\PENDD.SYS" 
points to the wacomos2.sys file from this disk. 

Modify the "TYPE=" argument, so it reads "TYPE=" TABLET_NUMBER. 
TABLET_NUMBER is defined below for all different tablets:

SD 510                  1
SD 420                  2
SD 320                  3  
SD 310                  4
SD 210                  5
SD 110                  6
SD 113                  7
SD 010                  8
SD 013                  9
                        10              // reserved
MS 2000                 11              // untested
PL 100V                 12              // at standard resolution
PL 200V                 13              // at standard resolution
PL 102V                 14              // at standard resolution
PL 100V                 15              // at European resolution
                        16              // reserved
                        17              // reserved
UD 0608                 18
ArtPad			19              
                        20              // reserved
                        21              // reserved 
                        22              // reserved
UD 1212                 23
UD 1218                 24

If you will be using a wacom pressure stylus on an SD tablet, add an 
argument to the  "DEVICE=.....\WACOMOS2.SYS" 
"PRESS=1".
Otherwise the driver expects a non pressure stylus.

If you will be using a wacom tablet on Comm2 add another argument to 
this line: "COMM=2".
Otherwise the driver expects the tablet to be on Comm1.

If you will be using a wacom tablet at 9600 baud add another argument to 
this line: "BAUD=1".
Otherwise the driver expects the tablet to be configured for 19200 baud.


Re-boot OS/2.

Pressure readings from the tablet should be available to PenPM
programmers according to IBM specs.

Direct any questions about setup or driver updates to Tom Picard 
at Wacom Technology (206)750-8884 ext 141. Fax (296) 750-8924. 
